RescueShell is remote shell access for Linux devices you have shipped and cannot reach directly. It is built for three situations: hardware on carrier-grade NAT, devices on customer networks where nobody will open a port for you, and small fleets that need support access without running a VPN.
A small agent on each device keeps one outbound HTTPS connection open on port 443. It does not use an HTTP proxy. When you open a shell, a second outbound connection to the same host carries it. Nothing is installed on the customer's network and no inbound port is opened.
Getting into a device takes more than reaching the relay: access also depends on device authentication, so a compromised relay does not open the devices. Updates are signature-checked before the agent replaces itself, and a failed update rolls back. Teams that prefer to control timing can switch auto-updates off. Agents older than 0.2.3 need one manual install of that version before they can self-update.
Requirements: a Linux device with OpenSSH (Dropbear is not supported). The agent is a static Go binary, needs no kernel module or tun device, and runs on a read-only root filesystem.
Pricing: the first device is free to try with no card, and the 30-day trial starts when it connects. Until a card is added, shell traffic is capped at 50 MB in total and a second device needs a card. Use without a card ends at 30 days or 50 MB, whichever comes first. After that it is 0.10 EUR per device per month, billed yearly, 6 EUR yearly minimum, plus VAT. Hosted in the EU; exceptions are listed on the EU residency page.